New Home Inspections

Many people believe that they don't need to have a new home inspected. We beg to differ with that. We often write some of our longer defect lists on new homes.

New Homes are built with much tighter tolerances than in years past. This generally means a better house, but it also means there is less "Safety Margin" in many of the systems and components as overbuilding is money the builder considers wasted. Many new components have very specific installation instructions which if not followed will void any warranties and may lead to premature failure.

Why "Built to code" is not a good thing.

"Code" is a set of MINIMUM building standards set forth by the Government for a safe and efficient house. Saying that a house is "Built to Code" is similar to saying "we built the cheapest house we could." Ideally, you want a house that EXCEEDS code in lots of places. i.e. it is stronger, more efficient and has more outlets and circuits than is required.

Won't the county inspectors find all the problems?

The local county or city inspectors are looking for different things than we are. They are looking for the gross issues that can cause structural failures or Major Life safety issues. They would like to say they look at all the same things we do, but it is a matter of time. They have 10-20 houses to look at in a day, we look at 1 or 2. We have the time to walk around in the attic, open the Electrical Panels, closets and cabinets, test a representative sample of outlets and windows, and examine individual beams and trusses along with looking into or at everything else we can.

Don't the builders care?

All builders want to build a good house. They also want to make a good profit and these two facts are in conflict. Most builders use sub contractors, and the subcontractors are motivated to work fast and cheap. It is also possible to have 7 to 8 different sub contractor crews working on a house, and they rarely talk to each other. If one crew puts something in the way of another, it just gets moved, cut or bored so they can do their job even if what was moved, cut or bored is not supposed to be moved, cut or bored.

What type things do you find?

On new house Final Walkthrough inspections, we break the inspection into two parts.

Cosmetic: (this is relatively unique to us, not many inspectors do this as it is not part of the formal inspection)

  • Scratches on Counters, cabinets and Fixtures
  • Scratches & Dents on appliances
  • Scratches and gouges in Hardwood floors
  • Paint on Carpets
  • Paint on Hardwood Floors
  • Trim paint (gloss) on Wall (flat)
  • Unpainted sections
  • Scratched Glass
  • Crooked Mullions on Windows
  • Windows that don't line up
  • Crooked Fixtures
  • Visible carpet seams
  • Exposed nails in Cabinets & Closets
  • Floor Squeaks
  • Crooked switches & outlets
  • Missing trim
  • We mark switched outlets in rooms

Structural, Safety and other traditional Inspection Items

  • Damaged Weather Stripping on doors
  • Doors that don't latch or operate smoothly
  • Windows that don't operate smoothly
  • Garage doors that are unbalanced or unsafe
  • Garage door openers that don't operate safely
  • Gap & Holes in the exterior siding
  • Cracked foundations
  • Untreated lumber used below grade
  • Exterior Air Conditioning units installed crooked
  • Exterior Air Conditioning units installed too close to
    each other or otherwise blocked airflow
  • Safety Disconnects placed improperly
  • Loose or unusable Hose faucets
  • Improper grading
  • Unsafe maintenance conditions for attic HVAC units
  • Downspouts and Sump pump outlets draining back to the foundation
  • Missing Shingles
  • Missing or damaged flashing
  • Lumber & Debris left on roof
  • Improperly installed appliances
  • Water temperatures set dangerously hot
  • Missing GFCI protection
  • Cracked, damaged or cut roof trusses
  • Cut, Bored or damaged floor Beams
  • Unsecured Beams or support posts
  • Unsupported beams
  • Improperly bundled wiring
  • Missing insulation
  • Insulation where it doesn't belong
  • Improperly installed insulation
  • Plumbing leaks (Water and waste)
  • Gas leaks
  • Open Electrical boxes
  • Recalled Electrical devices
  • Burn marks in Electrical Panel
  • Mis-wired outlets
  • Damaged Furnaces water heaters
  • Contaminated furnaces
  • Insufficient clearances for flues
  • Improperly installed appliances
  • Unconnected furnace ducting
  • Unconnected bath fan vents
  • Excessively long dryer duct runs
  • Disconnected dryer ducts
  • Damaged appliances
  • Sump pump pits full of construction debris
  • Flood damage
  • Gaps in Stair railings
  • Missing stair hand rails or railings
  • Broken Smoke detectors
  • Broken fireplaces
  • Hot/Cold water reversed at fixtures
  • Improper light fixtures used in/near showers & Tubs
  • Pull down attic stairs installed with trim nails

Does it matter who the builder is?

Not really. All builders have the same pool of sub-contractors to pull from. The house may be larger, have more options and trim, yet it is still built by the same sub contractor who also builds the inexpensive townhouses at the other end of the development. There are a few, truly custom home builders out there who build 2-3 houses per year who have their own crews but most large builders are working of 35-45 houses at a time, sometimes with multiple locations and multiple supervisors, each working that number of houses.

Do builders like Home Inspectors?

It is a love/hate relationship. They know that we help them build a better house by bringing another set of trained eyes to the house, and that a better house gets them better reviews & ratings and that means a better bonus in the end. However, in the short term we make them look bad and they have to scramble to fix all of the things we find so that the house can close on time.

Is there anything that can make things go smoother?

Ideally we would like to get in the house TWO WEEKS prior to your final walkthrough. The house needs to be ready "to Walk" at that time with everything turned on, installed, cleaned and prepped. They could have the walkthrough early if everything went well. This would give the builder time to calmly correct anything (everything) that we find, even if it is substantial. There are a few builders that work this way, but the majority are still painting and installing things the morning we are supposed to be there.

How long does a new home walkthrough inspection take?

Because the house is empty, clean and supposedly in good working order, the regular (traditional) inspection should go very quickly. We use the time that is saved to do our "fit-n-finish" inspection. We typically take about an hour and a quarter per 1,000 sq. ft. and then about 30-34 minutes for write-up and discussion. On large houses, that means we can be there for an entire day. A house that "has issues" can take significantly more time to document and discuss.